ECOVACS WINBOT W2S Window Cleaning Robot

1. Add ECOVACS WINBOT cleaning solution to the Water Tank.

2. Wet and wring out the Wiping Pad and place it flat on the velcro at the bottom of WINBOT. Pay attention to align the narrow and wide side accordingly.

3. Connect WINBOT Compound Cable, Power Adapter and Plug. Please ensure the battery is fully charged before using. Charging time will be approx. 4 hours.

* Do not power off WINBOT while it is running, as it may pose a risk of falling.

4. Tie the Safety Rope

Properly tie the Safety Rope to a stable object that cannot be easily moved (e.g. table leg, chair leg, bed leg, sofa leg, curtain rod, stair handrail, etc.), and lock the carabiner as shown below.

Note: When WINBOT is working, make sure there is someone nearby to supervise.

5. Long press START button for 2 seconds to start the fan. Place the bottom side of WINBOT (the side with Wiping Pad) against the window; WINBOT will auto-attach itself and start cleaning.

*Before cleaning, please observe the area to attach WINBOT for any small particles. If there are any, please remove them or switch to a particle-free area to avoid scratching the glass.

*Clean the Wiping Pad in time and make sure that any small particles on it are completely removed to avoid scratching the glass.

6. When cleaning is completed, WINBOT automatically returns to the Initial Spot and waits to be removed. At this point, long press START button for 2 seconds to stop the fan. Then, take WINBOT off according to voice prompts.

*If the vacuum glass, which WINBOT is working on, is leaking, remove WINBOT immediately after cleaning is completed.

Output power of the wireless module is less than 100 mW.

Note: Technical and design specifications may be changed for continues product improvement.

Scan the QR code for more information.